Subaru Outback manuals

Subaru Outback: Alarm system

It blinks to show the driver the operational status of the alarm system. For detailed information, refer to “Alarm system” F2- 15.

READ NEXT:

 Immobilizer system

This light blinks approximately 60 seconds after the ignition switch is turned from “ON” position to the “Acc” or “LOCK” position or immediately after the key is pulled out. Refer to

 Select lever/gear position indicator

1) Upshift/downshift indicator (AT and CVT models) This indicator shows the position of the shift lever (MT models) or select lever (AT and CVT models).

 Upshift/downshift indicator (AT and CVT models)

When the manual mode is selected, the gear position indicator (which shows the current gear selection) and the upshift/ downshift indicator light up. Refer to “Automatic transmission/Continuousl

SEE MORE:

 Rear Differential Front Oil Seal

A: INSPECTION Make sure that there is no leakage from front oil seal portion. If there is any leakage, replace the oil seal and inspect the propeller shaft. B: REPLACEMENT 1) Shift the select lever or gear shift lever to neutral. 2) Release the parking brake. 3) Disconnect the ground cable from ba

 Installing a booster seat

WARNING ● Child restraint systems and seatbelts can become hot in a vehicle that has been closed up in sunny weather; they could burn a small child. Check the child restraint system before you place a child in it. ● Do not leave an unsecured child restraint system in your vehicle.

© 2010-2023 Copyright www.suoutback.com