Subaru Outback manuals

Subaru Outback: Installation of accessories

Subaru Outback (BR) 2010-2015 Owners Manual / Audio / Installation of accessories

Always consult your SUBARU dealer before installing a citizen band radio or other transmitting device in your vehicle. Such devices may cause the electronic control system to malfunction if they are incorrectly installed or if they are not suited for the vehicle.

READ NEXT:

 Audio set

Your SUBARU may be equipped with one of the following audio sets. See the pages indicated in this section for operating details. NOTE If a cell phone is placed near the audio set, it may cause the

 Type A audio set (if equipped)

The audio set will operate only when the ignition switch is in the “Acc” or “ON” position. ● Power and sound controls: refer to page 5-6 ● Radio operation: refer to page 5-9

 Type B audio set (if equipped)

The audio set will operate only when the ignition switch is in the “Acc” or “ON” position. ● Power and sound controls: refer to page 5-6 ● Radio operation: refer to page 5-9

SEE MORE:

 Front Fender

A: REMOVAL 1) Disconnect the ground cable from battery. 2) Remove the bumper face assembly. Remove the clips, turn over the front mud guard, and disconnect the fog light connector. (Model with fog light) Remove the clips at the upper side of the bumper. Remove the clips from the fender.

 Valet mode

When you choose the valet mode, the alarm system does not operate. In valet mode, the remote transmitter is used only for locking and unlocking the doors and rear gate (Outback) and panic activation. To enter the valet mode, change the setting of your vehicle’s alarm system for deactivation

© 2010-2020 Copyright www.suoutback.com