Subaru Outback: Installation of accessories
Always consult your SUBARU dealer before installing fog lights or any other electrical
equipment in your vehicle. Such accessories may cause the electronic system to malfunction
if they are incorrectly installed or if they are not suited for the vehicle. We
recommend that you install only genuine SUBARU accessories on your vehicle.
READ NEXT:
WARNING
Bulbs may become very hot while illuminated. Before replacing bulbs, turn off
the lights and wait until the bulbs cool down, Otherwise, there is the risk of sustaining
a burn injury.
CAU
CAUTION
Halogen headlight bulbs become very hot while in use. If you touch the bulb surface
with bare hands or greasy gloves, fingerprints or grease on the bulb surface will
develop into hot spot
1. Pull off the fender lining. For details, refer to “Pulling off the fender
lining” F11- 7.
2. Remove the bulb cover, by turning it counterclockwise.
3. Disconnect the electrical connecto
SEE MORE:
A: INSPECTION
1. GENERAL PRECAUTION
Road tests should be conducted to properly diagnose the condition of CVT.
CAUTION:
Always observe the local traffic laws when performing the test.
2. D RANGE SHIFT FUNCTION
Make sure the engine speed is 1,100 - 1,300 rpm while driving on the level
road at 50 km/h
CAUTION
Direct splicing or other improper connection of trailer lights may damage your
vehicle’s electrical system and cause a malfunction of your vehicle’s lighting system.
Connection of trailer lights to your vehicle’s electrical system requires modifications
to the vehicle’s lightin
© 2010-2023 Copyright www.suoutback.com
