Subaru Outback: License plate light
Subaru Outback (BR) 2010-2015 Owners Manual / Maintenance and service / Replacing bulbs / License plate light
READ NEXT:
Outback
1. Remove the mounting screws using a Phillips screwdriver.
2. Remove the lens.
3. Pull the bulb out of the socket.
4. Install a new bulb.
5. Reinstall the lens.
6. Tighten the mounting screw
Dome light
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Turn the bulb until the flat surfaces at its ends are aligned vertically.
3. Pull the bulb straight downward to
Map light
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Turn the bulb until the flat surfaces at its ends are aligned vertically.
Pull the bulb straight downward to r
SEE MORE:
Gasoline for cleaner air
CAUTION
Do not let fuel spill on the exterior surfaces of the vehicle. Fuels containing
alcohol may cause paint damage, which is not covered under the SUBARU Limited Warranty.
Your use of gasoline with detergent additives will help prevent deposits from
forming in your engine and fuel system.
Knock Sensor
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the cover (A) and clip (B) from air intake
boot assembly.
3) Loosen the clamp (A) which connects the air intake
boot assembly and air cleaner case.
4) Loosen the clamp (B) which connects the air intake
boot assembly and throttle bo
© 2010-2023 Copyright www.suoutback.com
