Subaru Outback (BR): Headlight flasher
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Light control switch / Headlight flasher
CAUTION
Do not hold the lever in the flashing position for more than just a few seconds.
To flash the headlights, pull the lever toward you and then release it. The high beam will stay on for as long as you hold the lever. The headlight flasher works even though the lighting switch is in the “OFF” position.
When the headlights are on high beam, the high beam indicator light “
”
on the combination meter also illuminates.
READ NEXT:
Daytime running light system
WARNING
The brightness of the illumination of the high beam headlights is reduced by
the daytime running light system. The light switch must always be turned to the
“” position when it is dar
Turn signal lever
To activate the right turn signal, push the turn signal lever up. To activate
the left turn signal, push the turn signal lever down. When the turn is finished,
the lever will return automaticall
Illumination brightness control
The illumination brightness of the clock display, audio, air conditioner, multi
function display and meter/gauge dims under the following conditions.
● when the light switch is in the “
SEE MORE:
Ignition
General Description
A: SPECIFICATION
B: COMPONENT
Spark plug
Ignition coil
Tightening torque: N*m (kgf-m, ft-lb)
T1: 9 (0.9, 6.6)
T2: 21 (2.1, 15.5)
C: CAUTION
Wear appropriate work clothing, including a cap, protective goggles and
protective shoes when performing
any work.
Remove contam
Operation during cold weather
Carry some emergency equipment, such as a window scraper, a bag of sand, flares,
a small shovel and jumper cables. Check the battery and cables. Cold temperatures
reduce battery capacity. The battery must be in good condition to provide enough
power for cold winter starts.
Use an engine oil
© 2010-2026 Copyright www.suoutback.com
