Subaru Outback: Ashtray (if equipped)
CAUTION
● Do not use ashtrays as waste receptacles or leave a lighted cigarette in an ashtray. This could cause a fire.
● Always extinguish matches and cigarettes before putting them into the ashtray, and then close the ashtray securely. If you keep the ashtray open, the fire of the cigarette may spread to another cigarette butt and start a fire.
● Do not put flammable material in the ashtray.
● Do not leave a lot of cigarette butts in the ashtray.
The portable ashtray can be installed in each cup holder. For the locations of the cup holders, refer to “Cup holder” F6-8. When using the ashtray, open the lid of the ashtray. When removing the ashtray from a cup holder, pull the ashtray upwards. Fully close the lid after using the ashtray to help reduce residual smoke.
NOTE
Particles of ash and tobacco will accumulate around the hinges of the ashtray’s inner lid. Clean them off using a toothbrush or another narrow-ended implement.
READ NEXT:
Coat hook
WARNING
Do not hang coat hangers or other hard or pointed objects on the coat hooks.
If such items were hanging on the coat hooks during deployment of the SRS curtain
airbags, they could cause
Shopping bag hook
CAUTION
Do not hang items on the shopping bag hook that weigh 11 lbs (5 kg) or more.
Outback
A shopping bag hook is attached to each side of the cargo area.
To use the hook, push the upper portion and the shopping bag hook will appear.
SEE MORE:
Steering Gearbox
A: REMOVAL
1) Remove the cradle. <Ref. to FS-20, REMOVAL, Cradle.>
2) Remove the bolts, and remove left and right main mounting brackets.
3) Remove the bolts and remove the steering gearbox.
CAUTION:
Be careful not to damage the steering boot.
B: INSTALLATION
1) Before installation, check t
Selecting reverse gear
CAUTION
Shift into reverse ONLY when the vehicle has completely stopped. It may cause
damage to the transmission to try shifting into reverse when the vehicle is moving.
1) Slider
You must raise the slider and hold it in that position before you can move the
shift lever to the “R” posit
