Subaru Outback (BR): Rear window wiper and washer switch (Outback)

: Washer (accompanied by wiper operation)
ON: Continuous INT: Intermittent OFF: Off
: Washer (accompanied by wiper operation)
READ NEXT:
To turn the rear wiper on, turn the knob on the end of the wiper control lever
upward to the “INT” or “ON” position. To turn the wiper off, return the knob on
the end of the lever to the â
To wash the rear window while the rear wiper is operating, turn the knob on the
end of the wiper control lever upward to the “”
position. The washer fluid sprays until you release the knob. To
1) Rear window defogger
2) Outside mirror defogger (if equipped)
3) Windshield wiper deicer (if equipped)
The vehicle is equipped with a rear window defogger. Some models are also equipped
with
SEE MORE:
1. Close all windows.
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood is locked.
5. Close the doors (and the rear gate (Outback)) but leave only the driver’s door
or the front passenger’s door open.
6. Press the
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the glove box lid assembly.
3) Remove the main relay from the relay holder.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
1) Check that the main relay has no deformation,
cracks or other damages.
2) Measur
© 2010-2026 Copyright www.suoutback.com
