Subaru Outback (BR): Unfastening the front seatbelt
Subaru Outback (BR) 2010-2015 Owners Manual / Seat, seatbelt and SRS airbags / Seatbelts / Fastening the seatbelt / Unfastening the front seatbelt
Push the button on the buckle.
Before closing the door, make sure that the belts are retracted properly to avoid catching the belt webbing in the door.
READ NEXT:
Rear seatbelts (except rear center seatbelt on Outback)
1. Sit well back in the seat.
2. Pick up the tongue plate and pull the belt out slowly. Do not let it get twisted.
If the belt stops before reaching the buckle, return the belt slightly and pull
Unfastening the rear seatbelts seatbelt
Push the button on the buckle.
Before closing the door, make sure that the belts are retracted properly to avoid
catching the belt webbing in the door.
Rear center seatbelt on Outback
1) Center seatbelt tongue plate
2) Connector (tongue)
3) Connector (buckle)
4) Center seatbelt buckle
WARNING
Fastening the seatbelt with the webbing twisted can increase the risk or severity
SEE MORE:
Uniform tire quality grading standards
This information indicates the relative performance of passenger car tires in
the area of treadwear, traction, and temperature resistance. This is to aid the
consumer in making an informed choice in the purchase of tires.
Quality grades can be found where applicable on the tire sidewall between
Steering Column
A: REMOVAL
1) Adjust the tilt position to the lowest position and lock the tilt lever.
2) Remove the driver's airbag module assembly.
Push in the snap pin using a hexagon wrench or equivalent wrapped with a
protective tape to disengage
the locks (3 locations).
Disconnect the horn harness a
© 2010-2026 Copyright www.suoutback.com
