Subaru Outback (BR): Hazard warning flasher
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Hazard warning flasher
The hazard warning flasher is used to warn other drivers when you have to park your vehicle under emergency conditions. The hazard warning flasher works with the ignition switch in any position.
To turn on the hazard warning flasher, press the hazard warning button on the instrument panel. To turn off the flasher, press the button again.
NOTE
When the hazard warning flasher is on, the turn signals do not work.
READ NEXT:
Meters and gauges
NOTE
Liquid crystal displays are used in some of the meters and gauges in the combination
meter. You will find their indications hard to see if you wear polarized glasses.
Combination meter illumination
When the ignition switch is turned to the “ON” position, the various parts of
the combination meter are illuminated in the following sequence.
1. Warning lights, indicator lights, meter needles
Canceling the function for meter/gauge needle movement upon turning on the ignition
switch
It is possible to activate or deactivate the movement of the meter needles and
gauge needles that takes place when the ignition switch is turned to the “ON” position.
1. Turn the ignition swi
SEE MORE:
If the light is blinking
If the light is blinking while driving, an engine misfire condition has been
detected which may damage the emission control system.
To prevent serious damage to the emission control system, you should conform
to the following instructions.
● Reduce vehicle speed.
● Avoid hard acce
Airflow control buttons
Each airflow control button activates the following air outlets.
: Instrument panel outlets
: Instrument panel outlets and foot
outlets
: Foot outlets, both side outlets of
the instrument panel and some through windshield defroster outlets (A small amount
of air flows to the windshield
© 2010-2026 Copyright www.suoutback.com
