Subaru Outback (BR): Rear wiper
To turn the rear wiper on, turn the knob on the end of the wiper control lever upward to the “INT” or “ON” position. To turn the wiper off, return the knob on the end of the lever to the “OFF” position. With the switch turned to the “INT” position, the rear wiper will operate intermittently at intervals corresponding to the vehicle speed.
When you subsequently move the select lever to the “R” position (AT and CVT models) or the shift lever to the reverse position (MT models), the rear wiper will switch to continuous operation. When you move the select lever/shift lever from the “R” (reverse) position to another position, the rear wiper will return to intermittent operation.
READ NEXT:
Washer
To wash the rear window while the rear wiper is operating, turn the knob on the
end of the wiper control lever upward to the “”
position. The washer fluid sprays until you release the knob. To
Defogger and deicer
1) Rear window defogger
2) Outside mirror defogger (if equipped)
3) Windshield wiper deicer (if equipped)
The vehicle is equipped with a rear window defogger. Some models are also equipped
with
Mirrors
Always check that the inside and outside mirrors are properly adjusted before
you start driving.
SEE MORE:
Other sound setting controls (type A audio)
Each brief press of the “MENU” button changes the control modes in the following
sequence.
Choose the desired settings for each mode by turning the “TUNE/TRACK/CH” dial.
The control function returns to the tune/ track/channel control mode after approximately
5 seconds.
SVC setting
Basic Diagnostic Procedure of LAN System
A: PROCEDURE
CAUTION:
Subaru Select Monitor is required for reading DTC, performing diagnosis, reading current data, customizing and active test (compulsory drive).
Remove foreign matter (dust, water, oil, etc.) from each control module connector during removal and installation.
© 2010-2026 Copyright www.suoutback.com
