Subaru Outback manuals

Subaru Outback (BR): Displaying satellite radio ID of tuner

When you activate satellite radio, you should have your satellite radio tuner ID ready because each tuner is identified by its unique satellite radio tuner ID.

The satellite radio ID will be needed when you activate satellite radio and receive satellite radio customer support. The satellite radio ID can be found on the audio display by tuning the channel to “000”.

Turn the “TUNE/TRACK/CH” dial to select the satellite radio channel.

NOTE

For Sirius, change the display to an indication mode other than the channel number after performing the above operation.

READ NEXT:

 Band selection

Press the “SAT” button when the radio is off to turn on the radio. Press the “SAT” button when the radio is on to select SAT1, SAT2 or SAT3 reception.

 Channel and category selection

 Channel selection by operating the dial

Turn the “TUNE/TRACK/CH” dial clockwise to select the next channel and turn the “TUNE/TRACK/CH” dial counterclockwise to select the previous channel.

SEE MORE:

 AUX Input Terminal

A: REMOVAL 1. AUX INPUT TERMINAL 1) Disconnect the ground cable from battery. 2) Remove the console front cover assembly. MT model 1. Remove the shift knob. 2. Release the clips and claws, then pull up the console front cover assembly. NOTE: Turn over the front center pocket mat (a) and pull u

 3.6 L models

1) Power steering fluid reservoir (page 11-27) 2) Differential gear oil level gauge (page 11-26) 3) Automatic transmission fluid level gauge (page 11-24) 4) Brake fluid reservoir (page 11-28) 5) Fuse box (page 11-46) 6) Battery (page 11-45) 7) Windshield washer tank (page 11-40) 8) Engine o

© 2010-2026 Copyright www.suoutback.com