Subaru Outback (BR): Hands-free system (if equipped)
NOTE
● For models with the genuine SUBARU navigation system, refer to the Owner’s
Manual supplement for the navigation system.
● When selling your vehicle, make sure that you initialize the Hands-free system
to prevent personal data from being improperly accessed.
The Hands-free system operates while the ignition switch is in the “Acc” or “ON”
position.
READ NEXT:
Bluetooth®
NOTE
The Bluetooth word mark and logo are registered trademarks of Bluetooth SIG,
Inc.
It is possible to connect a cell phone to the in-vehicle equipment through the
Bluetooth ® fo
NOTE
● This device complies with Part 15 of the FCC Rules and with RSS-Gen of IC Rules.
Operation is subject to the following two conditions: (1) This device may not cause
harmful interfere
WARNING
● For safety reasons, avoid operating of the cell phone while driving.
● Do not make a phone call while driving. When you have an incoming call, stop the
vehicle in a safe loca
SEE MORE:
The tire pressure monitoring system alerts the driver by transmitting a signal from a sensor in each wheel when tire pressure drops significantly.
This system activates when the vehicle reaches speeds above 20 mph (32 km/h) and may not respond immediately to sudden drops in tire pressure,
To change the setting of your vehicle’s alarm system for activation or deactivation,
do the following.
1. Disarm the alarm system. Refer to “Disarming the system” F2-18.
2. Sit in the driver’s seat and shut all doors (and the rear gate (Outback)).
3. Turn the ignition switch to the “O
© 2010-2026 Copyright www.suoutback.com
