Subaru Outback (BR): Moonroof – if moonroof cannot be closed
Subaru Outback (BR) 2010-2015 Owners Manual / In case of emergency / Moonroof – if moonroof cannot be closed
If the moonroof cannot be closed with the moonroof switch, you can close the moonroof manually.
1. Take out the screwdriver from the tool bucket.
2. Open the overhead console. Refer to “Overhead console” F6-8.
3. Remove the two screws that retain the moonroof switch body. Then, remove the moonroof switch.
4. Insert the hex-head wrench in the end of the motor shaft.
To lower the moonroof, turn the wrench clockwise.
To close the moonroof, turn the wrench counterclockwise.
Have your vehicle checked and repaired by an authorized SUBARU dealer.
READ NEXT:
Washing
CAUTION
● When washing the vehicle, the brakes may get wet. As a result, the brake stopping
distance will be longer. To dry the brakes, drive the vehicle at a safe speed while
lightly press
SEE MORE:
How to connect and disconnect Airbag Connector
A: PROCEDURE
1. POWER SUPPLY
1) How to disconnect:
CAUTION: When pulling the slide lock or disconnecting connector, be sure to hold the connector, not the harness.
Push the lock (A).
While holding down the lock (A), disconnect the connector.
2) How to connect:
CAUTION: Be sure
Cylinder Head
A: REMOVAL
NOTE:
When replacing a single part, perform the work
with the engine assembly installed to body. Refer to
"Valve Clearance" for preparation procedures.
<Ref. to ME(H4SO)-29, Valve Clearance.>
When performing the work with the engine installed
to body, the following parts must
© 2010-2026 Copyright www.suoutback.com
