Subaru Outback (BR): Recommended fluid
Subaru Outback (BR) 2010-2015 Owners Manual / Maintenance and service / Automatic transmission fluid / Recommended fluid
NOTE
Using any non-specified type of automatic transmission fluid could result in damage inside the transmission. When replacing the automatic transmission fluid, be sure to use the specified type.
READ NEXT:
Continuously variable transmission fluid
There is no fluid level gauge. It is unnecessary to check the continuously variable
transmission fluid level. However, if necessary, consult your SUBARU dealer for
inspection.
Checking the oil level in AT models
AT models
1) Yellow handle
1. Park the vehicle on a level surface and stop the engine.
2. Pull out the level gauge, wipe it clean, and insert it again.
1) Upper level
2) Lower
SEE MORE:
Malfunction Indicator Light
A: PROCEDURE
B: ACTIVATION OF MALFUNCTION
INDICATOR LIGHT
1) When the ignition switch is turned to ON (engine
OFF), the malfunction indicator light (A) in the combination
meter illuminates.
NOTE:
If the malfunction indicator light does not illuminate,
perform diagnostics of the malfunction indicat
Drive Cycle
A: PROCEDURE
It is necessary to perform the drive cycle listed below if DTC is not found
in the Inspection Mode. It is possible
to complete diagnosis of the DTC by performing the indicated drive cycle. After
the repair for the DTC, perform
a necessary drive cycle and make sure the function recover
© 2010-2025 Copyright www.suoutback.com
