Subaru Outback (BR): Front differential gear oil (AT and CVT models)
Subaru Outback (BR) 2010-2015 Owners Manual / Maintenance and service / Front differential gear oil (AT and CVT models)
READ NEXT:
Checking the oil level in AT models
AT models
1) Yellow handle
1. Park the vehicle on a level surface and stop the engine.
2. Pull out the level gauge, wipe it clean, and insert it again.
1) Upper level
2) Lower
CVT models
There is no oil level gauge. To check the front differential gear oil level,
we recommend that you consult your SUBARU dealer for inspection.
SEE MORE:
Front Side Marker Light Bulb
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the clips and remove the air intake duct. (When removing the front
turn signal light bulb RH)
3) Turn the steering wheel in the opposite direction to the headlight to be
removed. Then remove the clips
and turn over the mud guard.
Activating and deactivating the alarm system
To change the setting of your vehicle’s alarm system for activation or deactivation,
do the following.
1. Disarm the alarm system. Refer to “Disarming the system” F2-18.
2. Sit in the driver’s seat and shut all doors (and the rear gate (Outback)).
3. Turn the ignition switch to the “O
© 2010-2026 Copyright www.suoutback.com
