Subaru Outback (BR): Windshield wiper and washer switches
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Wiper and washer / Windshield wiper and washer switches
The wiper operates only when the ignition switch is in the “ON” position.
READ NEXT:
Windshield wipers
MIST : Mist (for a single wipe)
OFF : Off
INT: Intermittent
LO: Low speed
HI: High speed
To turn the wipers on, push the wiper control lever down.
To turn the wipers off, return the lever to t
Wiper intermittent time control
When the wiper switch is in the “INT” position, turn the dial to adjust the operating
interval of the wiper. The operating interval can be adjusted in five steps from
the shortest interval t
Windshield washer
To wash the windshield, pull the wiper control lever toward you. The washer fluid
sprays until you release the lever. The wipers operate while you pull the lever.
NOTE
The windshield washer fl
SEE MORE:
Low tire pressure warning light (U.S.-spec. models)
When the ignition switch is turned to the “ON” position, the low tire pressure
warning light will illuminate for approximately 2 seconds to check that the tire
pressure monitoring system (TPMS) is functioning properly. If there is no problem
and all tires are properly inflated, the light
Front Side Marker Light Bulb
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the clips and remove the air intake duct. (When removing the front
turn signal light bulb RH)
3) Turn the steering wheel in the opposite direction to the headlight to be
removed. Then remove the clips
and turn over the mud guard.
© 2010-2026 Copyright www.suoutback.com
