Subaru Outback manuals

Subaru Outback (BR): Front fog light (if equipped)

Subaru Outback (BR) 2010-2015 Owners Manual / Maintenance and service / Replacing bulbs / Front fog light (if equipped)

NOTE

It may be difficult to replace the bulbs. We recommend that you have the bulbs replaced by your SUBARU dealer if necessary.

1. Pull off the fender lining. Refer to “Pulling off the fender lining” F11-7.

2. Disconnect the electrical connector.


2. Disconnect the electrical connector.

1) For left-hand side


1) For left-hand side

2) For right-hand side

3. Turn the socket clockwise (right-hand side) or counterclockwise (left-hand side).

4. Pull out the socket.

5. Pull out the bulb from the socket and replace the bulb with a new one.


5. Pull out the bulb from the socket and replace the bulb with a new one.

6. After replacing the bulb, reattach the fender lining.

READ NEXT:

 Rear combination lights

Legacy NOTE It may be difficult to replace the bulbs. We recommend that you have the bulbs replaced by your SUBARU dealer if necessary. 1. Turn the knobs of the cover 90 degrees counterclockwis

 Tail/Back-up light (Outback)

1. Apply a flat-head screwdriver to the light cover as shown in the illustration, and pry the light cover off from the rear gate trim. 1) Back-up light 2) Tail light 2. Turn the bulb socket c

SEE MORE:

 Ignition switch light

For easy access to the ignition switch in the dark, the ignition switch light illuminates when driver’s door is opened or when the driver’s door is unlocked using the remote keyless entry transmitter. The light remains illuminated for approximately 30 seconds and gradually turns off under

 System monitors

SRS airbag system warning light A diagnostic system continually monitors the readiness of the seatbelt pretensioner while the vehicle is being driven. The seatbelt pretensioners share the control module with the airbag system. Therefore, if any malfunction occurs in a seatbelt pretensioner,

© 2010-2026 Copyright www.suoutback.com