Subaru Outback manuals

Subaru Outback (BR): Rear seatbelts (except rear center seatbelt on Outback)

1. Sit well back in the seat.

2. Pick up the tongue plate and pull the belt out slowly. Do not let it get twisted. If the belt stops before reaching the buckle, return the belt slightly and pull it out more slowly. If the belt still cannot be unlocked, let the belt retract slightly after giving a strong pull on it, then pull it out slowly again.

3. Insert the tongue plate into the buckle until you hear a click.


3. Insert the tongue plate into the buckle until you hear a click.

4. To make the lap part tight, pull up on the shoulder belt.


4. To make the lap part tight, pull up on the shoulder belt.

5. Place the lap belt as low as possible on your hips, not on your waist.

READ NEXT:

 Unfastening the rear seatbelts seatbelt

Push the button on the buckle. Before closing the door, make sure that the belts are retracted properly to avoid catching the belt webbing in the door.

 Rear center seatbelt on Outback

1) Center seatbelt tongue plate 2) Connector (tongue) 3) Connector (buckle) 4) Center seatbelt buckle WARNING Fastening the seatbelt with the webbing twisted can increase the risk or severity

 Unfastening the rear center seatbelt

Push the release button of the center seatbelt buckle (on the left-hand side) to unfasten the seatbelt. 1. Insert a key or other hard pointed object into the slot in the connector (buckle)

SEE MORE:

 Viewing range on the screen

Range of view Range of view Image from camera The area from the rear end of the bumper can be viewed. Areas at both ends of the bumper and areas just under the bumper cannot be viewed. Also, the image from the rear view camera looks shorter than the actual distance. CAUTION The range t

 Cylinder Block

A: REMOVAL NOTE: Before conducting this procedure, drain the engine oil completely. 1) Remove the engine from the vehicle. <Ref. to ME(H4SO)-31, REMOVAL, Engine Assembly.> 2) Remove the intake manifold. <Ref. to FU(H4SO)-17, REMOVAL, Intake Manifold.> 3) Remove the crank pulley. <R

© 2010-2026 Copyright www.suoutback.com