Subaru Outback (BR): Emergency disarming
Subaru Outback (BR) 2010-2015 Owners Manual / Keys and doors / Alarm system / Disarming the system / Emergency disarming
If you cannot disarm the system using the transmitter (i.e. the transmitter is lost, broken or the transmitter battery is too weak), you can disarm the system without using the transmitter.
The system can be disarmed if you turn the ignition switch from the “LOCK” to the “ON” position with a registered key.
READ NEXT:
Valet mode
When you choose the valet mode, the alarm system does not operate. In valet mode,
the remote transmitter is used only for locking and unlocking the doors and rear
gate (Outback) and panic activati
Passive arming
When passive arming mode has been programmed by the dealer, arming of the system
is automatically accomplished without using the remote transmitter. Note that in
this mode, DOORS MUST BE MANUALLY
To enter the passive mode
If you wish to program the passive arming mode, have it done by your SUBARU dealer.
SEE MORE:
Rear Bumper
A: REMOVAL
1) Remove the rear combination light assembly.
Sedan model
1. Remove the trunk room trim. <Ref. to EI-127, REMOVAL, Trunk Room Trim.>
2. Disconnect the connector.
3. Release the nuts and clips, then remove the rear combination light assembly.
CAUTION:
Be careful not to damage t
Basic Diagnostic Procedure of Vehicle Dynamics Control
A: PROCEDURE
CAUTION: Remove foreign matter (dust, water, oil etc.) from the VDCCM&H/U connector during removal and installation.
NOTE:
To check the harness for open or short circuits, shake problem spot or connector.
Refer to "Check List for Interview". <Ref. to VD
© 2010-2026 Copyright www.suoutback.com
