Subaru Outback (BR): Charge warning light
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Warning and indicator lights / Charge warning light
If this light illuminates when the engine is running, it may indicate that the charging system is not working properly.
If the light illuminates while driving or does not turn off after the engine starts, stop the engine at the first safe opportunity and check the alternator belt. If the belt is loose, broken or if the belt is in good condition but the light remains illuminated, contact your nearest SUBARU dealer immediately.
READ NEXT:
Oil pressure warning light
CAUTION
Do not operate the engine with the oil pressure warning light on. This may cause
serious engine damage.
If this light illuminates when the engine is running, it may indicate that the
e
Engine low oil level warning light
The engine low oil level warning light illuminates when the ignition switch is
turned to the “ON” position and turns off after approximately 2 seconds.
This light also illuminates when the en
AT OIL TEMP warning light (AT and CVT models)
The AT oil temperature warning light “AT OIL TEMP” illuminates when the ignition
switch is turned to the “ON” position and turns off after approximately 2 seconds.
If this light illuminate
SEE MORE:
Read Diagnostic Trouble
Code (DTC)
A: OPERATION
NOTE:
For detailed operation procedures, refer to "PC
application help for Subaru Select Monitor".
For details concerning DTCs, refer to "List of Diagnostic
Trouble Code (DTC)". <Ref. to PB(diag)-
35, List of Diagnostic Trouble Code (DTC).>
Up to 3 DTCs are displayed in the
MT Gear Select Cable
A: REMOVAL
CAUTION:
Always use new MT gear select cable if the cable is removed from selector lever
COMPL of transmission
side.
1) Disconnect the ground cable from battery.
2) Remove the ten clips and remove the grille bracket.
3) Remove the air intake duct.
Non-turbo model
<Ref. to IN(H4S
© 2010-2026 Copyright www.suoutback.com
