Subaru Outback manuals

Subaru Outback (BR): AT OIL TEMP warning light (AT and CVT models)

The AT oil temperature warning light “AT OIL TEMP” illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 2 seconds. If this light illuminates when the engine is running, it may indicate that the transmission fluid temperature is too hot. If the light illuminates while driving, immediately stop the vehicle in a safe place and let the engine idle until the warning light turns off.

READ NEXT:

 Transmission control system warning

If the “AT OIL TEMP” warning light flashes after the engine has started, it may indicate that the transmission control system is not working properly. Contact your nearest SUBARU dealer for se

 Low tire pressure warning light (U.S.-spec. models)

When the ignition switch is turned to the “ON” position, the low tire pressure warning light will illuminate for approximately 2 seconds to check that the tire pressure monitoring system (TP

 Understanding the ABS Warning Light in Your Subaru Outback (BR)

  ABS warning light serves as an essential indicator of the Anti-Lock Braking System's operational status in your Subaru Outback (BR). When you turn the ignition switch to the “ON”

SEE MORE:

 Read Diagnostic Trouble Code (DTC)

A: OPERATION NOTE: For detailed operation procedures, refer to "PC application help for Subaru Select Monitor". For details concerning DTCs, refer to "List of Diagnostic Trouble Code (DTC)". <Ref. to PB(diag)- 35, List of Diagnostic Trouble Code (DTC).> Up to 3 DTCs are displayed in the

 Adjusting the front seat shoulder belt anchor height

The shoulder belt anchor height should be adjusted to the position best suited for the driver/front passenger. Always adjust the anchor height so that the shoulder belt passes over the middle of the shoulder without touching the neck. To raise: Slide the anchor up. To lower: Push the relea

© 2010-2026 Copyright www.suoutback.com