Subaru Outback (BR): Transmission control system warning
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Warning and indicator lights / AT OIL TEMP warning light (AT and CVT models) / Transmission control system warning
If the “AT OIL TEMP” warning light flashes after the engine has started, it may indicate that the transmission control system is not working properly. Contact your nearest SUBARU dealer for service immediately.
READ NEXT:
Low tire pressure warning light (U.S.-spec. models)
When the ignition switch is turned to the “ON” position, the low tire pressure
warning light will illuminate for approximately 2 seconds to check that the tire
pressure monitoring system (TP
Understanding the ABS Warning Light in Your Subaru Outback (BR)
ABS warning light serves as an essential indicator of the Anti-Lock Braking System's operational status in your Subaru Outback (BR). When you turn the ignition switch to the “ON”
Brake system warning light
WARNING
● Driving with the brake system warning light on is dangerous. This indicates
your brake system may not be working properly. If the light remains illuminated,
have the brakes insp
SEE MORE:
Checking the brake fluid level
CAUTION
Prevent brake fluid from coming into contact with your eyes, as it can cause harm. In case of eye contact, immediately rinse them thoroughly with clean water. It's recommended to wear eye protection when working with brake fluid for safety reasons.
Brake fluid has the ability to absorb moi
Pulling off the fender lining
It is necessary to pull off the fender lining when replacing some bulbs.
1. Start the engine and turn the steering wheel fully in the opposite direction
of the bulb to be replaced.
2. Stop the engine.
3. Remove the clip from the fender lining. Refer to “Type B clips” F11-5.
4. Pull off
© 2010-2026 Copyright www.suoutback.com
