Subaru Outback (BR): Turn signal lever
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Turn signal lever
To activate the right turn signal, push the turn signal lever up. To activate the left turn signal, push the turn signal lever down. When the turn is finished, the lever will return automatically. If the lever does not return after cornering, return the lever to the neutral position by hand.
To signal a lane change, push the turn signal lever up or down slightly and hold it during the lane change. The turn signal indicator lights will flash in the direction of the turn or lane change. The lever will return automatically to the neutral position when you release it.
READ NEXT:
Illumination brightness control
The illumination brightness of the clock display, audio, air conditioner, multi
function display and meter/gauge dims under the following conditions.
● when the light switch is in the “
Front fog light switch (if equipped)
The front fog lights operate under the following conditions.
● when the light switch is in the “”
position
● when the light switch is in the “AUTO” position and the headlight
Wiper and washer
WARNING
In freezing weather, do not use the windshield washer until the windshield is
sufficiently warmed by the defroster.
Otherwise the washer fluid can freeze on the windshield, blocking your v
SEE MORE:
Front Ball Joint
A: REMOVAL
1) Lift up the vehicle, and then remove the front wheels.
2) Remove the left and right stabilizer brackets.
3) Remove the ball joint.
Extract the cotter pin (a) from the ball stud.
Remove the castle nut (b).
Extract the ball stud from the front arm.
Remove the bolt securing the bal
Outer Mirror Assembly
A: REMOVAL
1) Remove the front door trim. <Ref. to EI-60, FRONT DOOR, REMOVAL, Door
Trim.>
2) Remove the outer mirror assembly.
Disconnect the connector.
Remove the bolts to remove outer mirror assembly.
B: INSTALLATION
Install each part in the reverse order of removal.
Tightening torqu
© 2010-2026 Copyright www.suoutback.com
