Subaru Outback (BR): Remote start confirmation transmitter feature
Subaru Outback (BR) 2010-2015 Owners Manual / Starting and operating / Remote engine start system (dealer option) / Remote start confirmation transmitter feature
Your remote engine start transmitter is equipped with a unique bidirectional confirmation feature. This feature will allow the transmitter’s backlit button to display the status of the system under the condition that the vehicle and transmitter are within the operational range of the system. Typical transmitter button flash sequences are outlined in the following chart.
READ NEXT:
Entering the vehicle following remote engine start shutdown
An alarm trigger may occur if the vehicle is opened by the remote keyless entry
transmitter within a few seconds immediately following remote engine start shutdown.
Pre-heating or pre-cooling the interior of the vehicle
Models with automatic climate control system:
After the system starts the engine, the automatic climate control system will
activate the “FULL AUTO” mode and heat or cool the interior to the pr
Service mode
In service mode, the remote engine start function is temporarily disabled to
prevent the system from unexpectedly starting the engine while being serviced.
To engage or disengage service mode:
1.
SEE MORE:
Selecting audible signal operation
Using an electronic chirp, the system will give you an audible signal when the
doors lock and unlock. If desired, you may turn the audible signal off.
To deactivate the audible signal, perform the following procedure. You can also
use the same steps to restore the function.
1. Sit in the drive
Ignition
General Description
A: SPECIFICATION
B: COMPONENT
Spark plug
Ignition coil
Tightening torque: N*m (kgf-m, ft-lb)
T1: 9 (0.9, 6.6)
T2: 21 (2.1, 15.5)
C: CAUTION
Wear appropriate work clothing, including a cap, protective goggles and
protective shoes when performing
any work.
Remove contam
© 2010-2026 Copyright www.suoutback.com
