Subaru Outback (BR): Remote engine start system (dealer option)
Subaru Outback (BR) 2010-2015 Owners Manual / Starting and operating / Remote engine start system (dealer option)
WARNING
● Do not remote start a vehicle in an enclosed environment (e.g. closed garage). Prolonged operation of a motor vehicle in an enclosed environment can cause a harmful build-up of Carbon Monoxide. Carbon Monoxide is harmful to your health. Exposure to high levels of Carbon Monoxide can cause headaches, dizziness or in extreme cases unconsciousness and/or death.
● Before performing any servicing of the vehicle, temporarily place the remote engine start system in service mode to prevent the system from unexpectedly starting the engine.
- Starting your vehicle
- Remote start safety features
- Entering the vehicle while it is running via remote start
- Remote start confirmation transmitter feature
- Entering the vehicle following remote engine start shutdown
- Pre-heating or pre-cooling the interior of the vehicle
- Service mode
- Remote transmitter program
- System maintenance
READ NEXT:
Starting your vehicle
NOTE
All vehicle doors, the engine hood and trunk / rear gate must be closed prior
to activating the remote engine start system. Any open entry point will prevent
starting or cause the system t
Remote start safety features
For safety and security reasons, the system will fail to start and honk the horn
twice or shut down the engine during remote start operation if any of the following
occur:
● Any of the door
Entering the vehicle while it is running via remote start
1. Unlock the vehicle doors using the remote keyless entry system. If the vehicle’s
doors are unlocked manually using the key, the vehicle’s alarm system will trigger
(if the alarm system is a
SEE MORE:
Security indicator light
The security indicator light deters potential thieves by indicating that the
vehicle is equipped with an immobilizer system. It begins flashing approximately
60 seconds after the ignition switch is turned from the “ON” position to the “Acc”
or “LOCK” position or immediately after
Headlight Assembly
A: REMOVAL
CAUTION:
Do not perform work with wet hands.
1) Disconnect the ground cable from battery.
2) Remove the clips and remove the air intake duct. (When removing the headlight
RH)
3) Remove the front bumper face assembly. <Ref. to EI-39, REMOVAL, Front
Bumper.>
4) Remove the fender
© 2010-2025 Copyright www.suoutback.com
