Subaru Outback (BR): System maintenance
Subaru Outback (BR) 2010-2015 Owners Manual / Starting and operating / Remote engine start system (dealer option) / System maintenance
NOTE
In the event that the vehicle’s battery is replaced, discharged or disconnected, it will be necessary to start the vehicle a minimum of one time using the key prior to activating the remote engine start system. This is required to allow the vehicle electronic systems to resynchronize.
READ NEXT:
Changing the batteries
CAUTION
● Do not let dust, oil or water get on or in the remote engine start transmitter
when replacing the battery.
● Be careful not to damage the printed circuit board in the remote
Manual transmission
WARNING
● Do not drive the vehicle with the clutch disengaged (i.e., when the clutch
pedal is depressed) or with the shift lever in the neutral position. Engine braking
has no effect in eit
Selecting reverse gear
CAUTION
Shift into reverse ONLY when the vehicle has completely stopped. It may cause
damage to the transmission to try shifting into reverse when the vehicle is moving.
1) Slider
You must rais
SEE MORE:
General Description of Starting-Charging Systems
A: SPECIFICATION
1. 2.5 L MODEL
2. 3.6 L MODEL
B: COMPONENT
1. STARTER
Starter housing
Magnet switch ASSY
Shift lever
Starter seal
Overrunning clutch ASSY
Washer
Planetary gear
Starter plate
Yoke
Armature
Brush holder ASSY
Drain
Ignition Switch Illumination
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the steering column cover.
Remove the screws by turning the steering wheel to right and left.
Release the claws and remove the steering column lower cover.
Separate the steering column upper cover and steering upper cover,
© 2010-2026 Copyright www.suoutback.com
