Subaru Outback (BR): Starting and operating
Subaru Outback (BR) 2010-2015 Owners Manual / Starting and operating
- Fuel filler lid and cap
- State emission testing (U.S. only)
- Preparing to drive
- Starting the engine
- Stopping the engine
- Remote engine start system (dealer option)
- Starting your vehicle
- Remote start safety features
- Entering the vehicle while it is running via remote start
- Remote start confirmation transmitter feature
- Entering the vehicle following remote engine start shutdown
- Pre-heating or pre-cooling the interior of the vehicle
- Service mode
- Remote transmitter program
- System maintenance
- Manual transmission
- Automatic transmission/Continuously variable transmission
- Transmission select lever
- Shift lock function
- Selection of manual mode
- Driving tips when using a Automatic transmission or Continuously variable transmission
- Power steering
- Braking
- ABS (Anti-lock Brake System)
- Electronic Brake Force Distribution (EBD) system
- Vehicle Dynamics Control system
- Basic information about tire pressure monitoring system (TPMS)
- Parking your vehicle
- Cruise control
READ NEXT:
SEE MORE:
Pulling off the fender lining
It is necessary to pull off the fender lining when replacing some bulbs.
1. Start the engine and turn the steering wheel fully in the opposite direction
of the bulb to be replaced.
2. Stop the engine.
3. Remove the clip from the fender lining. Refer to “Type B clips” F11-5.
4. Pull off
Rear view camera (if equipped)
Legacy
Outback
A rear view camera is attached to the trunk lid (Legacy) or rear gate (Outback).
When the ignition switch is “ON” and the shift lever (MT models) or select lever
(AT or CVT models) is set to “R”, the rear view camera automatically displays the
rear view image behin
© 2010-2026 Copyright www.suoutback.com
