Subaru Outback (BR): To set cruise control
Subaru Outback (BR) 2010-2015 Owners Manual / Starting and operating / Cruise control / To set cruise control
1. Press the “CRUISE” main switch button.
The cruise control indicator light on the combination meter will illuminate.
2. Depress the accelerator pedal until the vehicle reaches the desired speed.
3. Press the “RES/SET” switch to the “SET” side and release it. Then release the accelerator pedal.
At this time, the cruise control set indicator light is illuminated in the combination meter.
The vehicle will maintain the desired speed.
Vehicle speed can be temporarily increased while driving with the cruise control activated. Simply depress the accelerator pedal to accelerate the vehicle. When the accelerator pedal is released, the vehicle will return to and maintain the previous cruising speed.
READ NEXT:
To temporarily cancel the cruise control
The cruise control can be temporarily canceled in the following ways.
● Press the “CANCEL” button.
● Depress the brake pedal.
● Depress the clutch pedal (MT models only).
&
To turn off the cruise control
There are two ways to turn off the cruise control:
● Press the “CRUISE” main switch button again.
● Turn the ignition switch to the “Acc” or “LOCK” position (but only when th
SEE MORE:
Ignition
General Description
A: SPECIFICATION
B: COMPONENT
Spark plug
Ignition coil
Tightening torque: N*m (kgf-m, ft-lb)
T1: 9 (0.9, 6.6)
T2: 21 (2.1, 15.5)
C: CAUTION
Wear appropriate work clothing, including a cap, protective goggles and
protective shoes when performing
any work.
Remove contam
Front Door
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the front door trim. <Ref. to EI-60, FRONT DOOR, REMOVAL, Door Trim.>
3) Remove the outer mirror assembly. <Ref. to GW-28, REMOVAL, Outer Mirror
Assembly.>
4) Remove the front door speaker assembly.
Remove the screws
© 2010-2026 Copyright www.suoutback.com
