Subaru Outback (BR): To turn off the cruise control
Subaru Outback (BR) 2010-2015 Owners Manual / Starting and operating / Cruise control / To turn off the cruise control
There are two ways to turn off the cruise control:
● Press the “CRUISE” main switch button again.
● Turn the ignition switch to the “Acc” or “LOCK” position (but only when the vehicle is completely stopped).
READ NEXT:
To increase the speed (by the “RES/ SET” switch)
Press the “RES/SET” switch to the “RES” side and hold it until the vehicle reaches
the desired speed. Then, release the switch. The vehicle speed at that moment will
be memorized and tre
To increase the speed (by accelerator pedal)
1. Depress the accelerator pedal to accelerate the vehicle to the desired speed.
2. Press the “RES/SET” switch to the “SET” side once. Now the desired speed is
set and the vehicle will keep
SEE MORE:
ABS warning light
The ABS warning light illuminates when the ignition switch is turned to the “ON”
position and turns off after approximately 2 seconds.
This is an indication that the ABS system is working properly.
CAUTION
● If any of the following conditions occur, we recommend that you have the AB
Differential Gear Oil replacement
A: INSPECTION
1) Remove the filler plug, and then check the gear oil. Replace the gear oil if it is contaminated, deteriorated or cloudy. <Ref. to DI-23, REPLACEMENT, Differential Gear Oil.>
2) Check that the gear oil level is within -5 mm (- 0.2 in) from the bottom of the filler plug hole.
© 2010-2026 Copyright www.suoutback.com
