Subaru Outback (BR): Cruise control activation indicator light

The indicator light for cruise control activation illuminates upon turning the ignition switch to the “ON” position and remains lit for around 3 seconds.
This light becomes illuminated when the vehicle speed has been successfully set using the cruise control function.
READ NEXT:
The performance and long life of your vehicle are dependent on how you handle
and care for your vehicle while it is new. Follow these instructions during the
first 1,000 miles (1,600 km):
●
The following suggestions will help to save your fuel.
● Select the proper gear position for the speed and road conditions.
● Avoid sudden acceleration or deceleration. Always accelerate
SEE MORE:
A: REMOVAL
1) Remove the transmission assembly from the vehicle.
<Ref. to 5AT-37, REMOVAL, Automatic
Transmission Assembly.>
2) Disconnect the rear vehicle speed sensor connector.
NOTE:
Secure the transmission harness to the transmission
body using wire etc.
3) Remove the extension case.
To change from low beam to high beam, push the turn signal lever forward. When
the headlights are on high beam, the high beam indicator light “”
on the combination meter is also on.
To switch back to low beam, pull the lever back to the detent position.
© 2010-2026 Copyright www.suoutback.com
