Subaru Outback (BR): Starting the engine
Subaru Outback (BR) 2010-2015 Owners Manual / Starting and operating / Starting the engine
READ NEXT:
MT models
1. Apply the parking brake.
2. Turn off unnecessary lights and accessories.
3. Depress the clutch pedal to the floor and shift the shift lever into neutral.
Hold the clutch pedal to the floor whil
AT and CVT models
CAUTION
If you restart the engine while the vehicle is moving, shift the select lever
into the “N” position. Do not attempt to place the select lever of a moving vehicle
into the “P” posi
Stopping the engine
WARNING
Do not stop the engine when the vehicle is moving. This will cause loss of power
to the power steering and the brake booster, making steering and braking more difficult.
It could also res
SEE MORE:
Basic Diagnostic Procedure of HVAC System
A: PROCEDURE
NOTE: When the sunload sensor check is performed indoors or in the shade, it could be diagnosed as sensor having an open circuit. Always perform the inspection in direct sunlight.
General Description
A: CAUTION
1) Never connect the battery in reverse polarity.
Doing so may
Front Side Marker Light Bulb
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the clips and remove the air intake duct. (When removing the front
turn signal light bulb RH)
3) Turn the steering wheel in the opposite direction to the headlight to be
removed. Then remove the clips
and turn over the mud guard.
© 2010-2026 Copyright www.suoutback.com
