Subaru Outback (BR): Battery drainage prevention function
If a door or the rear gate (Outback) is not completely closed, the interior lights will remain illuminated as a result. However, several lights are automatically turned off by the battery drainage prevention function to prevent the battery from going dead. The following interior lights are affected by this function.
*1: The map lights can be controlled by the battery drainage prevention function only when the map light switches are in the OFF position and the door interlock switch is in the DOOR position. For the switch positions, refer to “Map light” F6-2.
*2: The door step lights are not affected by the battery drainage prevention function, so the lights do not turn off automatically. To turn off the lights, it is necessary that each door is completely closed.
The operational/non-operational setting of this function can be changed by a SUBARU dealer. Contact the nearest SUBARU dealer if you would like to change the setting.
NOTE
● The factory setting (default setting) for this function is set as “operational”.
● When leaving the vehicle, please make sure that all doors and the rear gate (Outback) are completely closed.
● The battery drainage prevention function does not operate while the key is in the ignition switch.
READ NEXT:
Power door locking switches
1) Lock
2) Unlock
All doors and the rear gate (Outback) can be locked and unlocked by the power
door locking switches located at the driver’s side and the front passenger’s side
doors. To
Key lock-in prevention function
This function prevents the doors from being locked with the key still in the
ignition switch.
Behavior with key lock-in prevention function operational
With the driver’s door open, the doors are automatically kept unlocked even if
the front side of the power door locking switch is pressed.
SEE MORE:
Manual Transmission Mounting System
A: REMOVAL
1. CROSSMEMBER AND CUSHION RUBBER
1) Disconnect the ground cable from battery.
2) Lift up the vehicle.
3) Remove the front under cover. <Ref. to EI-35, REMOVAL, Front Under Cover.>
4) Remove the front and center exhaust pipes. (non-turbo model) <Ref. to EX(H4SO)-5, REMOVAL,
Calculating total and load capacities varying seating configurations
Calculate the available load capacity as shown in the following examples:
Example 1A
Vehicle capacity weight of the vehicle is 800 lbs (363 kg), which is indicated
on the vehicle placard with the statement “The combined weight of occupants and
cargo should never exceed 363 kg or 800 lbs”
