Subaru Outback (BR): Display selection in satellite radio
Subaru Outback (BR) 2010-2015 Owners Manual / Audio / Satellite radio operation (if equipped) / Display selection in satellite radio
Press the “TEXT” button while receiving the satellite radio to change the display as follows:
READ NEXT:
CD player operation
NOTE
● Make sure to always insert a disc with the label side up. If a disc is inserted
with the label side down, the player displays “CHECK DISC”. Refer to “When the following
message
How to insert a CD (type A)
While the ignition switch is in the “Acc” or “ON” position, hold a disc with
a finger in the center hole while gripping the edge of the disc, then insert it
in to the slot (with the label
How to insert a CD(s) (type B)
1. Briefly press the “LOAD” button. If the magazine in the player has an idle
position where you can insert a disc, the disc number indicator associated with
the idle position will blink.
I
SEE MORE:
Continuously Variable Transmission Mounting System
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Lift up the vehicle.
3) Remove the center exhaust pipe. <Ref. to EX(H4SO)-8, REMOVAL, Center Exhaust Pipe.>
4) Remove the heat shield cover.
5) Set the transmission jack under the transmission. Make sure that the support plate
Scan tuning (SCAN)
If you press the “SCAN” button, the radio will switch to the scan mode. In this
mode, the radio scans through the radio band until a station is found. The radio
will stop at the station for 5 seconds while displaying the frequency, after which
scanning will continue until the entire band
© 2010-2026 Copyright www.suoutback.com
