Subaru Outback (BR): Engine
READ NEXT:
Lubricants
Engine oil
For the checking, adding and replacing procedure or other details, refer to “Engine oil” F11-12.
NOTE
The procedure for changing the engine oil and oil filter should be perf
Fluids
*1: Use one of the indicated types of fluid.
*2: The indicated fluid quantity is only a guideline. The necessary quantity for replacement may differ slightly depending on the temperature a
SEE MORE:
Rear Drive Shaft, Reduction Driven Gear
A: REMOVAL
1) Remove the transmission assembly from the vehicle.
<Ref. to 5AT-37, REMOVAL, Automatic Transmission Assembly.>
2) Remove the rear vehicle speed sensor, and then remove the extension case. <Ref. to 5AT-65, REMOVAL, Extension Case.>
3) Pull out the rear drive shaft from c
Continuously Variable Transmission Mounting System
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Lift up the vehicle.
3) Remove the center exhaust pipe. <Ref. to EX(H4SO)-8, REMOVAL, Center Exhaust Pipe.>
4) Remove the heat shield cover.
5) Set the transmission jack under the transmission. Make sure that the support plate
© 2010-2026 Copyright www.suoutback.com
