Subaru Outback (BR): FM reception
Although FM is normally static free, reception can be affected by the surrounding area, atmospheric conditions, station strength and transmitter distance. Buildings or other obstructions may cause momentary static, flutter or station interference. If reception continues to be unsatisfactory, switch to a stronger station.
READ NEXT:
Audio set
Your SUBARU may be equipped with one of the following audio sets. See the pages
indicated in this section for operating details.
NOTE
If a cell phone is placed near the audio set, it may cause the
Type A audio set (if equipped)
The audio set will operate only when the ignition switch is in the “Acc” or “ON”
position.
● Power and sound controls: refer to page 5-6
● Radio operation: refer to page 5-9
SEE MORE:
Low beam light bulbs
1. Pull off the fender lining. For details, refer to “Pulling off the fender
lining” F11- 7.
2. Remove the bulb cover, by turning it counterclockwise.
3. Disconnect the electrical connector.
4. Remove the retainer spring.
5. Replace the bulb, then set the retainer spring securely.
Expansion Valve
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Using the refrigerant recovery system, discharge refrigerant. <Ref. to AC-24,
PROCEDURE, Refrigerant
Recovery Procedure.>
3) Remove the connector and bolts, and remove the high-pressure hose and AC pipe
from the expansion
valve.
4
© 2010-2026 Copyright www.suoutback.com
