Subaru Outback (BR): Audio set
Subaru Outback (BR) 2010-2015 Owners Manual / Audio / Audio set
Your SUBARU may be equipped with one of the following audio sets. See the pages indicated in this section for operating details.
NOTE
If a cell phone is placed near the audio set, it may cause the audio set to emit noise when the phone receives calls. This noise does not indicate an audio set malfunction. Note that a cell phone should be placed as far as possible from the audio set.
READ NEXT:
Type A audio set (if equipped)
The audio set will operate only when the ignition switch is in the “Acc” or “ON”
position.
● Power and sound controls: refer to page 5-6
● Radio operation: refer to page 5-9
Type B audio set (if equipped)
The audio set will operate only when the ignition switch is in the “Acc” or “ON”
position.
● Power and sound controls: refer to page 5-6
● Radio operation: refer to page 5-9
SEE MORE:
Power seat (if equipped)
WARNING
To prevent the passenger from sliding under the seatbelt in the event of a collision,
always put the seatback in the upright position while the vehicle is in motion.
Also, do not place objects such as cushions between the passenger and the seatback.
If you do so, the risk of sliding
Clutch Switch
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the instrument panel lower cover. <Ref.
to EI-64, REMOVAL, Instrument Panel Lower Cover.>
3) Disconnect the connector from clutch switch.
4) Remove the clutch switches.
B: INSTALLATION
1. CLUTCH SWITCH
1) Move the clevis pin
© 2010-2026 Copyright www.suoutback.com
