Subaru Outback (BR): Fuse panel located in the passenger compartment




READ NEXT:
NOTE
Lights A and B are the LED (Light Emitting Diode) type. Consult your SUBARU dealer
for replacement.
WARNING
Bulbs may become very hot while illuminated. Before replacing bulbs, turn of
1) Emission control label
2) Vehicle identification number
3) Certification and bar code label
4) Tire inflation pressure label
5) Vehicle identification number plate
6) Model number label
7)
SEE MORE:
A: REMOVAL
1) Remove the front pillar trim.
Pull the upper part of the front pillar trim towards the center of the
vehicle.
Insert long-nose pliers into the top part of the trim, grip the clip
with the pliers and twist 90º in that position.
CAUTION:
Be careful not to damage the pillar trim
A: PROCEDURE
CAUTION:
Subaru Select Monitor is required for reading DTC, performing diagnosis, reading current data, customizing and active test (compulsory drive).
Remove foreign matter (dust, water, oil, etc.) from each control module connector during removal and installation.
© 2010-2026 Copyright www.suoutback.com
