Subaru Outback (BR): Fuse panel located in the engine compartment

A) Main fuse



READ NEXT:
NOTE
Lights A and B are the LED (Light Emitting Diode) type. Consult your SUBARU dealer
for replacement.
WARNING
Bulbs may become very hot while illuminated. Before replacing bulbs, turn of
1) Emission control label
2) Vehicle identification number
3) Certification and bar code label
4) Tire inflation pressure label
5) Vehicle identification number plate
6) Model number label
7)
SEE MORE:
A: PROCEDURE
Perform the diagnosis shown in the following DTC table.
When performing the diagnosis not listed in "List of Diagnostic Trouble Code (DTC)",
refer to the item on the
drive cycle. <Ref. to EN(H4SO)(diag)-45, Drive Cycle.>
1. PREPARATION FOR THE INSPECTION
MODE
1) Check that the
Your remote engine start transmitter is equipped with a unique bidirectional
confirmation feature. This feature will allow the transmitter’s backlit button to
display the status of the system under the condition that the vehicle and transmitter
are within the operational range of the system.
© 2010-2026 Copyright www.suoutback.com
