Subaru Outback (BR): Hill Holder indicator light

WARNING
If the Hill Holder indicator light does not illuminate even when the Hill Holder
switch is pressed to activate the Hill Holder function, the electronic parking brake
system may be malfunctioning. Immediately stop the vehicle in a safe location and
contact your SUBARU dealer.
The light illuminates when the ignition switch is turned to the “ON” position
and turns off after approximately 2 seconds.
The light illuminates when the Hill Holder switch is pressed to activate the
Hill Holder function.
READ NEXT:
The low fuel warning light illuminates when the tank is nearly empty approximately
2.6 US gal (10.0 liters, or 2.2 Imp gal). It only operates when the ignition switch
is in the “ON” position
When the ignition switch is in the “ON” position, the door open warning light
illuminates for approximately 2 seconds and then turns off.
The door open warning light illuminates if any door,
When any of the doors, the rear gate (Outback) or the trunk lid (Legacy) is not
fully closed, the door open indicator light illuminates. This function is effective
even if the ignition switch is
SEE MORE:
CAUTION
● After turning the ignition switch to the “ON” position, if this indicator light/warning
light behaves under any of the following conditions, the electrical system may be
malfunctioning. Contact your SUBARU dealer immediately for an inspection.
– It remains blinking in RED
A: REMOVAL
1) Remove the cradle. <Ref. to FS-20, REMOVAL, Cradle.>
2) Remove the bolts, and remove left and right main mounting brackets.
3) Remove the bolts and remove the steering gearbox.
CAUTION:
Be careful not to damage the steering boot.
B: INSTALLATION
1) Before installation, check t
© 2010-2026 Copyright www.suoutback.com
