Subaru Outback (BR): Scan tuning (SCAN)
Subaru Outback (BR) 2010-2015 Owners Manual / Audio / FM/AM radio operation / Tuning / Scan tuning (SCAN)
If you press the “SCAN” button, the radio will switch to the scan mode. In this mode, the radio scans through the radio band until a station is found. The radio will stop at the station for 5 seconds while displaying the frequency, after which scanning will continue until the entire band has been scanned.
Press the “SCAN” button again to cancel the SCAN mode. If you press the “SCAN” button while the radio is stopped at a station, the radio stays stopped at that station. If you press the button while the radio is scanning, the radio stops at the next receivable station.
Automatic tuning may not function properly if the station reception is weakened by distance from the station or proximity to tall buildings and hills.
READ NEXT:
PTY (Program type) group tuning (only FM reception)
Press the “PTY/CAT” button to change to the PTY selection mode. At this time,
the PTY group that you are currently listening to will be displayed for 10 seconds.
In PTY selection mode, “PT
RDS text display
If the PS (Program Service Name) and/or RT (Radio Text) are available, pressing
the “TEXT” button changes the display among PS, RT and frequency. The initial setting
is “PS”.
NOTE
`
Station preset
Preset buttons
SEE MORE:
Alarm system
The alarm system helps to protect your vehicle and valuables from theft. The
horn sounds and the turn signal lights flash if someone attempts to break into your
vehicle.
The system can be armed and disarmed with the remote transmitter.
The system does not operate when the key is inserted into
Manual transmission
WARNING
● Do not drive the vehicle with the clutch disengaged (i.e., when the clutch
pedal is depressed) or with the shift lever in the neutral position. Engine braking
has no effect in either of these conditions and the risk of an accident is consequently
increased.
● Do not eng
© 2010-2026 Copyright www.suoutback.com
