Subaru Outback (BR): Immobilizer
The immobilizer system is designed to prevent an unauthorized person from starting the engine. Only keys registered with your vehicle’s immobilizer system can be used to operate your vehicle. Even if an unregistered key fits into the ignition switch and can be turned to the “START” position, the engine will automatically stop after several seconds.
Each immobilizer key contains a transponder in which the key’s ID code is stored. When a key is inserted into the ignition switch and turned to the “ON” position, the transponder transmits the key’s ID code to the immobilizer system’s receiver. If the transmitted ID code matches the ID code registered in the immobilizer system, the system allows the engine to be started. Since the ID code is transmitted and acted upon almost instantly, the immobilizer system does not impede normal starting of the engine. If the engine does not start, pull out the key once before trying again. Refer to “Ignition switch” F3-3.
This device complies with Part 15 of the FCC Rules and RSS-Gen of IC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CAUTION
● Do not place the key under direct sunlight or anywhere it may become hot.
● Do not get the key wet. If the key gets wet, wipe it dry with a cloth immediately.
● FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE
To protect your vehicle from theft, please pay close attention to the following
security precautions:
● Never leave your vehicle unattended with its keys inside.
● Before leaving your vehicle, close all windows and lock the doors (all models) and rear gate (Outback).
● Do not leave spare keys or any record of your key number in the vehicle.
READ NEXT:
Security ID plate
1) Key number plate
2) Security ID plate
The security ID is stamped on the security ID plate attached to the key set.
Write down the security ID and keep it in another safe place, not in the veh
Security indicator light
The security indicator light deters potential thieves by indicating that the
vehicle is equipped with an immobilizer system. It begins flashing approximately
60 seconds after the ignition switch
Key replacement
Your key number plate and security ID plate will be required if you ever need
a replacement key made. Any new key must be registered for use with your vehicle’s
immobilizer system before it can
SEE MORE:
Oil Pressure System
A: WIRING DIAGRAM
B: INSPECTION
Engine Oil
A: INSPECTION
CAUTION:
If the engine oil is spilt over exhaust pipe or the
under cover, wipe it off with cloth to avoid emitting
smoke or causing a fire.
1) Park the vehicle on a level surface.
2) Remove the oil level gauge and wipe away the
oil.
3) Rei
Rear window wiper blade rubber (Outback)
1. Pull out the end of the blade rubber assembly to unlock it from the plastic
support.
2. Pull the blade rubber assembly out of the plastic support.
1) Metal spines
3. If the new blade rubber is not provided with two metal spines, remove the
metal spines from the old blade rubber and i
