Subaru Outback (BR): Outback License plate light
Subaru Outback (BR) 2010-2015 Owners Manual / Maintenance and service / Replacing bulbs / Outback License plate light
1. Remove the mounting screws using a Phillips screwdriver.
2. Remove the lens.
3. Pull the bulb out of the socket.
4. Install a new bulb.
5. Reinstall the lens.
6. Tighten the mounting screws.
READ NEXT:
Dome light remove bulb
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Turn the bulb until the flat surfaces at its ends are aligned vertically.
3. Pull the bulb stra
Map light bulb replacing
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Turn the bulb until the flat surfaces at its ends are aligned vertically. Pull the bulb straigh
Vanity mirror light
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Pull the bulb out of the socket.
3. Install a new bulb.
4. Reinstall the lens.
SEE MORE:
Connecting a trailer
1. Remove the receiver cover from the hitch receiver tube. Then insert the ball
mount into the hitch receiver tube.
2. Insert the hitch pin into the hole on the hitch receiver tube so that the
pin passes through the ball mount.
3. Insert the safety pin onto the hitch pin securely.
4. Pull
Front Vehicle Speed Sensor
A: REMOVAL
1) Remove the transmission assembly from the vehicle.
<Ref. to 5AT-37, REMOVAL, Automatic
Transmission Assembly.>
2) Disconnect the rear vehicle speed sensor connector.
NOTE:
Secure the transmission harness to the transmission
body using wire etc.
3) Remove the extension case.
© 2010-2026 Copyright www.suoutback.com
