Subaru Outback (BR): Vanity mirror light
Subaru Outback (BR) 2010-2015 Owners Manual / Maintenance and service / Replacing bulbs / Vanity mirror light
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Pull the bulb out of the socket.
3. Install a new bulb.
4. Reinstall the lens.
READ NEXT:
Door step light
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Pull the bulb out of the socket.
3. Install a new bulb.
4. Reinstall the lens.
Cargo area light (Outback) bulb replacing
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Pull the bulb out of the socket.
3. Install a new bulb.
4. Reinstall the lens.
Other bulbs
Other bulbs may be difficult to replace. We recommend that you have the bulbs
replaced by your SUBARU dealer if necessary.
SEE MORE:
Pulling off the fender lining
It is necessary to pull off the fender lining when replacing some bulbs.
1. Start the engine and turn the steering wheel fully in the opposite direction
of the bulb to be replaced.
2. Stop the engine.
3. Remove the clip from the fender lining. Refer to “Type B clips” F11-5.
4. Pull off
Front Side Marker Light Bulb
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the clips and remove the air intake duct. (When removing the front
turn signal light bulb RH)
3) Turn the steering wheel in the opposite direction to the headlight to be
removed. Then remove the clips
and turn over the mud guard.
© 2010-2026 Copyright www.suoutback.com
