Subaru Outback (BR): Selecting preset channels
Subaru Outback (BR) 2010-2015 Owners Manual / Audio / Satellite radio operation (if equipped) / Channel preset / Selecting preset channels
Presetting a channel with a preset button allows you to select that channel in a single operation. Up to six SAT1, SAT2 and SAT3 channels each may be preset.
READ NEXT:
Display selection in satellite radio
Press the “TEXT” button while receiving the satellite radio to change the display as follows:
CD player operation
NOTE
● Make sure to always insert a disc with the label side up. If a disc is inserted
with the label side down, the player displays “CHECK DISC”. Refer to “When the following
message
How to insert a CD (type A)
While the ignition switch is in the “Acc” or “ON” position, hold a disc with
a finger in the center hole while gripping the edge of the disc, then insert it
in to the slot (with the label
SEE MORE:
Scan tuning (SCAN)
If you press the “SCAN” button, the radio will switch to the scan mode. In this
mode, the radio scans through the radio band until a station is found. The radio
will stop at the station for 5 seconds while displaying the frequency, after which
scanning will continue until the entire band
Synthetic oil
You should use synthetic engine oil that meets the same requirements given for
conventional engine oil. When using synthetic oil, you must use oil of the same
classification, viscosity and grade shown in this Owner’s Manual. Refer to “Engine
oil” F12-4. Also, you must follow the oil and
© 2010-2026 Copyright www.suoutback.com
