Subaru Outback: Stowage of the cargo area cover
The cargo area cover can be stowed in under the cargo floor.

1. To open the lid, pull the handle up.

2. To keep the lid open, hang the hook (provided on the back of the lid) on the
rear edge of the roof.

3. Remove the left and right parts of the cargo floor lid.

4. Stow the cover housing in the cargo area end.
READ NEXT:
1. To install the cover housing, insert both ends of the cover housing into the
retainers.
2. Make sure to fix the front part of the cargo area cover behind the rear seat.
CAUTION
The convenient tie-down hooks are designed only for securing light cargo. Never
try to secure cargo that exceeds the capacity of the hooks. The maximum load capacity
is 44 lbs (20 kg) per
The subfloor storage compartment is located under the floor of the trunk or cargo
area and can be used to store small items. To open the lid, pull the tab or handle
up.
NOTE
When storing a flat
SEE MORE:
A: REMOVAL
1) Remove the transmission assembly from the vehicle.
<Ref. to 5AT-37, REMOVAL, Automatic
Transmission Assembly.>
2) Disconnect the rear vehicle speed sensor connector.
NOTE:
Secure the transmission harness to the transmission
body using wire etc.
3) Remove the extension case.
A: INSPECTION
Check for transmission gear oil leaks at oil seal area.
If there is an oil leak, replace the oil seal with
new one and check the propeller shaft.
B: REPLACEMENT
1) Remove the collector cover. (turbo model)
2) Lift up the vehicle.
3) Remove the front under cover. <Ref. to EI-35,
© 2010-2023 Copyright www.suoutback.com
