Subaru Outback (BR): Cargo area cover (if equipped)
Subaru Outback (BR) 2010-2015 Owners Manual / Interior equipment / Cargo area cover (if equipped)
The cargo area cover is provided for covering the cargo area and to protect its contents from direct sunlight. This cover is detachable to make room for additional cargo.
- Using the cover
- To remove the cover housing
- Stowage of the cargo area cover
- To install the cover housing
READ NEXT:
Using the cover
To extend the cover, pull the end of the cover out of the housing, then insert
its hooks into the catches as shown. To rewind it, unhook it from the catches and
it will rewind automatically. You
To remove the cover housing
1. Rewind the cover.
2. Hold down the button on the righthand rear quarter panel and lift up the right-hand
cover housing.
3. Remove the cover housing.
Stowage of the cargo area cover
The cargo area cover can be stowed in under the cargo floor.
1. To open the lid, pull the handle up.
2. To keep the lid open, hang the hook (provided on the back of the lid) on the
rear edge o
SEE MORE:
Rear seats
WARNING
Seatbelts provide maximum restraint when the occupant sits well back and upright
in the seat. Do not put cushions or any other materials between occupants and seatbacks
or seat cushions. If you do so, the risk of sliding under the lap belt and of the
lap belt sliding up over the abd
Moonroof – if moonroof cannot be closed
If the moonroof cannot be closed with the moonroof switch, you can close the
moonroof manually.
1. Take out the screwdriver from the tool bucket.
2. Open the overhead console. Refer to “Overhead console” F6-8.
3. Remove the two screws that retain the moonroof switch body. Then, remove the
© 2010-2026 Copyright www.suoutback.com
