Subaru Outback (BR): VDC warning light / VDC operation indicator light
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Warning and indicator lights / VDC warning light / VDC operation indicator light
The light illuminates when the ignition switch is turned to the “ON” position and turns off several seconds after the engine has started. This lighting pattern indicates that the Vehicle Dynamics Control system is operating normally.
READ NEXT:
Vehicle Dynamics Control warning light
CAUTION
The Vehicle Dynamics Control system provides its ABS control through the electrical
circuit of the ABS system. Accordingly, if the ABS is inoperative, the Vehicle Dynamics
Control system
Vehicle Dynamics Control operation indicator light
The indicator light flashes during activation of the skid suppression function
and during activation of the traction control function.
NOTE
● The light may remain illuminated for a short per
Vehicle Dynamics Control OFF indicator light
The light illuminates when the ignition switch is turned to the “ON” position
and turns off after approximately 2 seconds. The light illuminates when the Vehicle
Dynamics Control OFF switch
SEE MORE:
Upper Inner Trim
A: REMOVAL
1) Remove the front pillar trim.
Pull the upper part of the front pillar trim towards the center of the
vehicle.
Insert long-nose pliers into the top part of the trim, grip the clip
with the pliers and twist 90º in that position.
CAUTION:
Be careful not to damage the pillar trim
ABS Sequence Control
A: OPERATION
1) While the ABS sequence control is being performed, the operation of the
hydraulic unit can be checked using
the brake tester or pressure gauge after the hydraulic unit solenoid valve
operation.
2) ABS sequence control can be started by the Subaru Select Monitor.
1. ABS SEQUENCE CO
© 2010-2026 Copyright www.suoutback.com
