Subaru Outback (BR): Vehicle Dynamics Control OFF indicator light
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Warning and indicator lights / Vehicle Dynamics Control OFF indicator light
The light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 2 seconds. The light illuminates when the Vehicle Dynamics Control OFF switch is pressed to deactivate the Vehicle Dynamics Control system.
The Vehicle Dynamics Control system is probably malfunctioning under any of the following conditions. Have your vehicle checked at a SUBARU dealer immediately.
● The light does not illuminate when the ignition switch is turned to the “ON” position.
● The light does not turn off even after a period of approximately 2 seconds after the ignition switch has been turned to the “ON” position.
READ NEXT:
Immobilizer system
This light blinks approximately 60 seconds after the ignition switch is turned from “ON” position to the “Acc” or “LOCK” position or immediately after the key is
SEE MORE:
Rearview Camera System
A: WIRING DIAGRAM
Refer to "Rearview Camera System" in the wiring diagram. <Ref. to WI-213,
WIRING DIAGRAM, Rearview
Camera System.>
B: REMOVAL
1. SEDAN MODEL
1) Disconnect the ground cable from battery.
2) Remove the trunk lid trim.
Remove the trunk handle.
Remove the clips and the trunk
Cradle
A: REMOVAL
1) Set the vehicle on a lift.
2) Adjust the tilt position of the steering column to the lowest position and
lock the tilt lever.
3) Prevent the steering wheel from turning using the seat belt.
4) Remove the front wheels.
5) Disconnect the ground cable from battery.
6) Remove the air
© 2010-2026 Copyright www.suoutback.com
