Subaru Outback (BR): Immobilizer system
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Warning and indicator lights / Immobilizer system
This light blinks approximately 60 seconds after the ignition switch is turned from “ON” position to the “Acc” or “LOCK” position or immediately after the key is pulled out. Refer to “Immobilizer” F2-3. If the indicator light does not flash, it may indicate that immobilizer system may be malfunctioning. Contact your nearest SUBARU dealer immediately. In the event that an unauthorized key (for example, an unauthorized duplicate) is used, the security indicator light illuminates.
READ NEXT:
Select lever/gear position indicator
1) Upshift/downshift indicator (AT and CVT models)
This indicator shows the position of the shift lever (MT models) or select lever
(AT and CVT models).
Upshift/downshift indicator (AT and CVT models)
When the manual mode is selected, the gear position indicator (which shows the
current gear selection) and the upshift/ downshift indicator light up. Refer to
“Automatic transmission/Continuousl
Gear position indicator setting (MT models)
The gear position indicator light can be activated or deactivated by performing
the following procedure.
1. Turn the ignition switch to the “LOCK” position.
2. Press the trip knob to show “
SEE MORE:
P (Park)
This position is for parking the vehicle and starting the engine.
In this position, the transmission is mechanically locked to prevent the vehicle
from rolling freely.
When you park the vehicle, first apply the parking brake, then shift into the
“P” position. Do not hold the vehicle with o
Replacing the air cleaner element
Replace the air cleaner element according to the maintenance schedule in the
“Warranty and Maintenance Booklet”. Under extremely dusty conditions, replace it
more frequently. It is recommended that you always use genuine SUBARU parts.
Non-turbo models
1) Hydraulic hose
2) Connector
3)
© 2010-2026 Copyright www.suoutback.com
