Subaru Outback (BR): Ventilation
To force outside air through the instrument panel outlets:
1. Set the air inlet selection button to the OFF position.
2. Press the “
” button.
3. Set the temperature control dial all the way left.
4. Set the fan speed control dial to the desired speed.
When driving on a dusty road, set the air inlet control button to the ON position.
WARNING
Continued operation in the ON position may fog up the windows. Switch to the
OFF position as soon as the outside dusty condition clears.
READ NEXT:
For cooling and dehumidification of the passenger compartment, air flows through
the instrument panel outlets:
1. Set the air inlet selection button to the OFF position.
2. Press the “” button
To direct warm air to the windshield and front door windows:
1. Press the “” button.
2. Set the temperature control dial to the red side.
3. Set the fan speed control dial at the highest speed.
SEE MORE:
A: REMOVAL
1. FRONT HOOD INSULATOR
Release the clips to remove the front hood insulator.
CAUTION:
Do not reuse any clips damaged during removal. The damaged clip cannot fix the
insulator securely.
Therefore, always replace with a new part.
2. FRONT HOOD SEAL
Remove the clip, and remove the seal.
This position is for restarting a stalled engine.
In this position the wheels and transmission are not locked. In this position,
the transmission is neutral; the vehicle will roll freely, even on the slightest
incline unless the parking brake or foot brake is applied. Avoid coasting with the
© 2010-2026 Copyright www.suoutback.com
